Skip to product information
1 of 3

UNMRKD BEAUTY

BOND MAXIMISER

Regular price £8.99 GBP
Regular price Sale price £8.99 GBP
Sale Sold out
Tax included. Shipping calculated at checkout.

We like our lashes just as we like our coffee- Hot AND strong!

If you’ve ever forgotten to use a top-coat on your manicure before, -then you’ll understand why our Bond Maximiser sealant is the icing-on-the-cake to our UNDERLASH system! Sealing in the bond for the long haul, Bond Maximiser is applied as a last step, before a final brush through with a clean spoolie to make sure each lash is not only beautiful, – but strong too!

It’s all about maximising retention!

Housed in a mascara-like tube. Helps to remove bond stickiness. Apply directly to lashes or use the end sponge on your applicator and pinch!

Dont get wet for 24hours after applying. 

Ingredients:

Isododecane, Trimethylsiloxysilicate, Aqua, VP/Eicosene Copolymer, Polypropylsilsesquioxane, Glycerin, Hydrogenated Polyisobutene, Hydroxypropylcellulose, Polysorbate 20, Phenoxyethanol, Ethylhexylglycerin

Sensory guide :

This stage is optional but id you hate the tacky feeling it will massively help remove that. The application is similar to a mascara wand with a soft sponge on the end so you can apply the thin water like formula to the roots of your underlashes. Be mindful of how much you apply as a little goes a long way and too much can cause “frosting” (hardened sealant) to dry on the lashes which will cause discomfort. Not to worry as the lashes are easily removed with our remover (oil stick, no cotton wool needed!) and fully reusable! Which is good for if your first testing out the system and need to start again until you figure out the correct amounts for you!

Thin water like formula. Can harden if too much is applied. Optional stage to our underlash system.

Ingredients

Mega lash bond -

Acrylates/Ethylhexyl Water, Butylene Glycol, Ethanol, Carbon Black, AMP-Acrylates Copolymer, Phenoxyethanol, Citric Acid, Sorbitol, Ceteareth-25, Sodium Carbonate, Cellulose Gum, Ethylhexylglycerin

Bond maximiser -

Isododecane, Trimethylsiloxysilicate, Aqua, VP/Eicosene Copolymer, Polypropylsilsesquioxane, Glycerin, Hydrogenated Polyisobutene, Hydroxypropylcellulose, Polysorbate 20, Phenoxyethanol, Ethylhexylglycerin

Care Instructions

Carefully remove lashes from the card using fingers slowly.

Like any adhesive it's very important to perform a patch test before application. Whilst we do take every precaution to ensure our products are non-toxic & suitable for even sensitive eyes, it may not suit every skin type. 

Apply a small amount of bond behind your ear (lower section) & wait 24 hours to see if any irritation occurs.

If irritation occurs, rinse the area immediately with warm water for a few minutes, discontinue use of the product straight away. If irritation persists please seek medical advice. 

Same applies to our bond maximiser and remover.

See our page on how to apply, remove, clean and reuse here