UNMRKD BEAUTY
REMOVAL WAND
Couldn't load pickup availability
When used correctly the removal will be completely damage free.
- Generously brush our remover over the top & bottom of your lashes.
- Wait 20/30 seconds, get a cotton pad & wipe to remove. Repeat if needed.
- Once you have removed the lashes you will have bond residue on your natural lashes, repeat the above on your natural lashes until they are free from bond residue.
Do not apply a new set of lashes without cleaning your lashes & eye area first to make sure they are free from the remover residue. If there is any remover residue left on your natural lashes you will not successfully be able to apply a new set.
If you notice a couple of your natural lashes in with the segments whilst removing please don't panic as your natural lashes shed daily so you have not pulled them out it was just their time to fall out naturally.
Ingredients : white mineral oil, laureth-4, isododecane, 2-phenoxyethanol, tween 80, ethyl hexyl glycerol
Sensory guide :
A stick filled with all the essential soothing oils to remove your underlashes easily. It is a plastic wand with very small ridges. Oil based product with a slight scent. We hated standard removal oils you have to use with cotton wool. So if you are the same then you might just love this one! Brush onto the lashes and remove with the item of your preference whether that be baby wipes, pressed cotton pads, tissue, or cotton wool if your crazy ha ha, the choice is yours!
Oily - Slightly scented.
Ingredients
Ingredients
Mega lash bond -
Acrylates/Ethylhexyl Water, Butylene Glycol, Ethanol, Carbon Black, AMP-Acrylates Copolymer, Phenoxyethanol, Citric Acid, Sorbitol, Ceteareth-25, Sodium Carbonate, Cellulose Gum, Ethylhexylglycerin
Bond maximiser -
Isododecane, Trimethylsiloxysilicate, Aqua, VP/Eicosene Copolymer, Polypropylsilsesquioxane, Glycerin, Hydrogenated Polyisobutene, Hydroxypropylcellulose, Polysorbate 20, Phenoxyethanol, Ethylhexylglycerin
Care Instructions
Care Instructions
Carefully remove lashes from the card using fingers slowly.
Like any adhesive it's very important to perform a patch test before application. Whilst we do take every precaution to ensure our products are non-toxic & suitable for even sensitive eyes, it may not suit every skin type.
Apply a small amount of bond behind your ear (lower section) & wait 24 hours to see if any irritation occurs.
If irritation occurs, rinse the area immediately with warm water for a few minutes, discontinue use of the product straight away. If irritation persists please seek medical advice.
Same applies to our bond maximiser and remover.
See our page on how to apply, remove, clean and reuse here
